Bitmain APW3++
In Stock Out of Stock Ships after Will be in stock by
$1,999.00
Save
APW3++ is a power supply from BITMAIN that can deliver a 1600W for the BITMAIN miners. It is energy efficient and the official power supply for the BITMAIN Antminer S9 & Antminer L3+.
Pre-Buying Guide
- The power cord is not included. Requires a power cord with at least 10A capacity.
- The APW3++ can deliver a maximum power of only 1200W if it is connected to a 110V mains power supply. To obtain the rated power of 1600W, the APW3++ must be connected to a 220-240V mains power supply.
- This batch of PSU comes with only 10 PCIe connectors, so it can not be used with more than one
Antminer S9 /Antminer L3+ miners.
Specifications
| Output | DC Voltage | 12.15V |
|---|---|---|
| Rated Current (220V input) | 133A | |
| Rated Current (110V input) | 100A | |
| Rated Power (220V input) | 1600W | |
| Rated Power (110V input) | 1200W | |
| Ripple & Noise | <1% | |
| Voltage Regulation | <2% | |
| Source Regulation | <1% | |
| Load Regulation | <1% | |
| Setup, Rise Time | <2S | |
| Power off Protection Trip Time | >9mS | |
| Interface Type | 5 pairs of 6 pin PCI-E connectors (i.e. 10 connectors) | |
| Noise Level | <43DB | |
| Input | Voltage Range | 100-240V AC |
| Starting Voltage | 95-105V AC | |
| Frequency Range | 47-63Hz | |
| Power Factor | >0.95 (full load) | |
| Leakage Current | <1.5mA (220V 50Hz) | |
| Protection | Low-voltage Input | 80-89V AC |
| Output Short Circuit | Yes | |
| Output Overcurrent | 134-185A max. | |
| Overheat Protection | Yes | |
| Environment Conditions | Operating Temperature | -20°C - 50°C |
| Operating Humidity | 20% - 90% relative humidity (non-condensing) | |
| Structure | Dimensions | 220mm*108mm*62mm |
| Cooling | Fan | Forced-air cooling |